- PROBE BUDDY SIMULATOR -

GX web pics 1100x900 - Probe_Buddy

PROBE BUDDY SIMULATOR

PROBES PROCESS & FLOW CONTROLS PRODUCTS

OXYGEN PROBE SIMULATOR & TESTER

Probe Buddy™ is a smart testing device that checks the integrity and health of an oxygen probe from United Process Controls and other manufacturers. It is also used to imitate the output signals of a working probe to check the scaling and operation of the process control system.

Troubleshoot problems with your probe and control system
Through simulation of the probe – All the elements of the control system can be verified including wiring between the probe and controller, and the calibration of the inputs on the controller
Impedance test assess the probe’s usability and performance
Eliminate unneeded replacement of non-defective probes and provide probe vendor trouble shooting information about the system performance
Carbon, Dew Point, and Oxygen calculations are featured in both measuring and simulation modes

Categories PROBES, PROCESS & FLOW CONTROLS, PRODUCTS

Hand-held device operates as a probe test meter and a probe signal simulator
Enables non-expert to perform probe troubleshooting procedures like an expert
Accepts selectable TC and mV inputs from any oxygen probe
Outputs selectable TC and mV signals to simulate an oxygen probe
Performs a probe impedance test when connected to a probe
Computes carbon, dewpoint or oxygen in input or output mode
Specific probe connection cables available, no hard wiring required
Easy access connection

Additional information

Weight	5 lbs
Dimensions	5.57998884 × 4.02999194 × 2.78999442 in

Power	9V Battery
Operating Temperature	5-550C (41-1310F)
Storage Temperature	-20-700C (-4-1580F)
Dimensions	16.2 x 8.3 x 2.6 cm
	(6.37” x 3.25” x 1.03”)
Weight	1.04 lkg (2.3 lb)
Available Processes	Oxygen, Dewpoint, Carbon
Thermocouples	B, K, R, S
Millivolt Range	0-2000mV

Brochure ProbeBuddy

Manual ProbeBuddy